Soudal Fix All Turbo 290ml

For all bonding applications where adhesive strength build up speed is highly critical or important. Heavy-duty bonding in all weather conditions, on most surfaces. Suitable for bonding porous (i.e. natural stone) and non-porous surfaces.

APPLICATION

Application method
Apply the adhesive by means a caulking gun in uniform adhesive strips or dots (every 15 cm) on one of the substrates. Always apply an adhesive dot or strip on the corner and edges of panels. Do not apply the glue in a closed circumference, but interrupted. Bond the substrate and tamp with a rubber hammer. If necessary, support the bonded materials. For bonding on absorbent and porous substrates with thin adhesive layer, the adhesive is already hand tight after approx. 20 minutes and can be loaded after about 3 hours. Thicker adhesive layers or nonabsorbent substrates extend the curing time.

Cleaning
With Fix ALL Cleaner immediately after use. Cured Fix ALL Turbo can only be removed mechanically.

Finishing
With a soapy solution or Soudal Finishing Solution before skinning.

Repair
With the same material.

LIMITATIONS

– Fix ALL Turbo can not be used as a glazing sealant.
– Not suitable for bonding aquariums.
– Do not use in applications where continuous water immersion is possible.
– Not suitable for sanitary applications.
– Fix ALL Turbo can be used for bonding of natural stone, but it cannot be used as a joint sealant on this type of surface. Fix ALL Turbo can therefore only be used on the bottom of natural stone tiles.
– When applying, make sure that the surface of the materials is not smudged with sealant.