APPLICATION
The instructions for the can must strictly be observed. Ideal working temperature for the foam is 20o C. If necessary, gently warm chilled cans in lukewarm water before use. Do not heat cans
above 50°C as there is risk of bursting. Shake the can for at least 30 seconds then fix the foam gun to the can. The can will operate in any position.
If fixing boards, apply beads to the back of the board wait approximately 2 minutes then press the board into place. If using insulation board apply 3 beads approximately 25mm wide to the
board. If using plasterboard apply approximately 400mm apart. Use mechanical fixings if working overhead. Apply the boards in rows, starting from the bottom of the wall, and going up to the top to avoid sliding. Apply to the substrate within 5 minutes of applying adhesive (depending on ambient conditions) and press firmly across the whole face of the board, starting at the top. Apply subsequent boards ensuring edges are firmly butted up at this stage.
Hold board in place for approx 1 minute until adhesive is cured enough to hold the board on its own. Plastering can commence after 1 hour!
If using a gun and you have not used all the can, clean the gun using Bond It GUN FOAM CLEANER, screw in proportioning screw which will ensure the foam will be usable for up to approximately 4 weeks.
LIMITATIONS
Not recommended for use on polyethylene, silicone, oil and grease.
Anonymous (verified owner) –
good service
mark prescott (verified owner) –
5 star. great experience. Highly recommend
Mark (verified owner) –
Good product worked well
Guy D. (verified owner) –
good stuff
Stewart Taylor (verified owner) –
good and cheep